eLab6

> Price

Features and Onboard Facilities

The eLab6 incorporates the PIC12F675 microcontroller from Microchip Technology Inc. (USA). As this chip contains FLASH MEMORY, you do not have to take it off the board to use/apply the program. The board can be used to input/output signals, switches, sound, LED's etc. Together with the MDriver, a motor driver module, the eLab6 can be used to interface with small motors and solenoids. Many configurations are possible with the eLab6! 

• Flash Memory - Can be electrically programmed on-board over 1,000,000 times

• 1 Kilobyte Instruction space - Can store 1024 instructions

• 6 Input/Output Bits - Can be used in a variety of configurations

• Separate Power Supply

• Programmable via the USB port module

Kit Contents

Printed Circuit Board (PCB)

• 43mm x 50mm

• Tinned and Solder Masked

• Component Overlay Diagram (on top)

Various Electrical Components

• 100k Ohm resistor x 1

• 390 Ohm resistor x 3

• Light Dependent resistor x 1

• Red LED x 1

• Orange LED x 1

• Green LED x 1

• IN4004 Diode x 1

• 100nF Ceramic Capacitor x 1

• 100uF Electrolytic Capacitor x 1

• Piezo Buzzer x 1

• Push Button Switch x 1

• Slide Switch x 1

• 8 Pin IC socket x 1

• 8 Pin Microcontroller IC x 1 (Microchip PIC12F675)

• 10 Pin Program Connector x 1

• 2 Way PCB Terminal Block x 1

• 3 Way PCB Terminal Block x 2

• 4.5V Battery Holder x 1

• 3 Pin Battery Connector x 1

• 150mm Lengths of Red Wire x 6

• 150mm Lengths of Black Wire x 6

^Price                                                                 

                Built and Tested: AU$13.20 inc. GST

Related links

> ezSystem Inventors Tool Kit

> ezCD Projects

> ezCoreChart

> ezCircuit Designer (Standard)

> ezCircuit Designer (ezSystem)

> MDriver