eLab6p

The eLab6p is the prototyping version of the eLab6. Like the eLab6, it incorporates the PIC12F675 microcontroller from Microchip Technology Inc. (USA). As this chip contains FLASH MEMORY, you do not have to take it off the board to use/apply the program. The board can be used for prototyping of simple LED circuits to transistor drives for motor outputs. Many configurations are possible.

Features:

• Flash Memory - Can be electrically programmed on-board over 1,000,000 times
• 1 Kilobyte Instruction space - Can store 1024 instructions
• 6 Input/Output Bits - Can be used in a variety of configurations
• Separate Power Supply
• Programmable via the USB Programmer

Microchip Parts

• Printed Circuit Board (PCB)
  • 89mm x 51mm
  • Tinned and Solder Masked
  • Component Overlay Diagram (on top)
• Various Electrical Components
  • 1x 100k Ohm resistor
  • 3x 390 Ohm resistor
  • 1x 1N4004 Diode
  • 1x 100nF Ceramic Capacitor
  • 1x 100uF Electrolytic Capacitor
  • 1x Slide Switch
  • 1x 8 Pin IC socket
  • 1x 8 Pin Microcontroller IC (Microchip PIC12F675)
  • 1x 10 Way Program Connector
  • 1x 2 Way PCB Terminal Block
  • 2x 3 Way PCB Terminal Block
  • 1x 4.5V Battery Holder
  • 1x 3 Pin Battery Connector

Price

AU$16.00	(elab6p)
AU$44.00	(Required: USB Programmer) (Part of ezSystem Starter Tool kit & eLab6 Inventor Tool kit)