eLab6

Features:

The eLab6 incorporates the PIC12F675 microcontroller from Microchip Technology Inc. (USA). As this chip contains FLASH MEMORY, you do not have to take it off the board to use/apply the program. The board can be used to input/output signals, switches, sound, LED's etc. Together with the MDriver a motor driver module, the eLab6 can be used to interface with small motors and solenoids. Many configurations are possible with the eLab6.

• Flash Memory - Can be electrically programmed on-board over 1,000,000 times
• 1 Kilobyte Instruction space - Can store 1024 instructions
• 6 Input/Output Bits - Can be used in a variety of configurations
• Separate Power Supply
• Programmable via the USB Programmer

Microchip Parts

• Printed Circuit Board (PCB)
  • 43mm x 50mm
  • Tinned and Solder Masked
  • Component Overlay Diagram (on top)
• Various Electrical Components
  • 1x 100k Ohm resistor
  • 1x IN4004 Diode
  • 1x 100nF Ceramic Capacitor
  • 1x 100uF Electrolytic Capacitor
  • 1x Slide Switch
  • 1x 8 Pin IC socket
  • 1x 8 Pin Microcontroller IC (Microchip PIC12F675)
  • 1x 10 Pin Program Connector
  • 1x 2 Way PCB Terminal Block
  • 2x 3 Way PCB Terminal Block
  • 1x 4.5V Battery Holder
  • 1x 3 Pin Battery Connector

Price

AU$13.20	(eLab6) (Note: included in eLab6 Inventors Tool kit)
AU$44.00	(Required: USB Programmer) (Part of ezSystem Inventors Tool kit & eLab6 Inventors Tool kit)
AU$77.00	(eLab6 Inventors Tool kit)